Wash Pads and Water Capture
Pollution of surface waters and groundwater
It is an offence for anyone to cause or knowingly permit: the entry into surface waters or groundwater of solid waste matter, or of poisonous, noxious or polluting matter, or the discharge of trade and sewage effluent into surface waters or groundwater without prior consent from the Environmental Regulator.
Good Practise
You should carry out dewaxing , cleaning and degreasing activities in designated washbay areas and not on ground which discharges to surface water drains, watercourses or soakaways. A water recycling system can reduce water use and associated costs. The washbay should be impermeable and isolated by a raised kerb, with the effluent directed to foul sewer or a sealed pump. Never direct the drainage from these areas through an oil interceptor as the oil will be emulsified and washed out of the interceptor.
All WashMan Wash Pads eliminate the need to install a permanent concrete wash pad, which is both more expensive and not always viable if the land is not freehold.
Inflatable Wash Pads
for temporary and multiple locations.
Semi-permanent Wash Pads
for sites with a duration of two to three years.
Permanent surface mounted Wash Pads
for hostile or corrosive longer term applications.
VapourSteam low water volume steam cleaners, where a standard saloon car can be steam cleaned with around just one glass of water, reducing the levels of contaminated water run off and the need to contain excessive quantities of water.
AquaBoom Spill Containment System
for containing and managing water and other liquids.
Water Treatment and Water Reclaim
From this point we can supply any of the following options;
A surface mounted 3 stage interceptor connected to a foul drain.
A surface mounted 3 stage interceptor to a water recycling system.
Connection to our integral 'Valet Centre 20' combined water reclaim and interceptor.
Introducing the NEW Total Wash and Reclaim System
The integral and self contained water reclaim system...
Provides clean water to an integral 1500 psi cold water pressure washer at up to 20 Litres per minute.
Water is collected directly from the wash pad or capture system and directed to the internal filters.
Integral interceptor is housed in a stainless steel frost-proof cabinet for protection against vandalism and frost.
Automatic control provides fresh water top-up and automatic dosing to the integral interceptor with a 'one-switch' system for the operator.
The system is fully tested and part of a range of products supplied and services by Morclean throughout the U.K.
| [ Morclean Home Page | Special Offers | Latest News | Contact Us ] | |||||
|
|
Freephone 0800 1300 402 For export enquiries: export@morclean.com If you have any comments about this site contact office@morclean.com |
Morclean (West Midlands) |
|
||
 Morclean is an ISO 9001 registered firm and our quality administration systems have been assured and approved to the standards and guidelines of BS EN ISO 9000:2000 for the sales, service and hire of industrial cleaning equipment. Our registration no. is 94/121120 and our standards and guidelines are externally audited by CIS. Please note that many models described on this website are bespoke, and as such cannot always be accurately depicted. All photographs and illustrations displayed on this website are representative of model ranges or a model series only. Individual models and specifications may vary from those shown. Please contact us if you require clarification or individual specifications of any equipment. Morclean reserve the right to update and amend the specification of our equipment and accessories without notice and in the interest of the customer. Images or specifications must not be reproduced with express written consent from Morclean Ltd. Any prices quoted are subject to VAT @ SR. E&OE Registered in England No. 4605133 |
|||||
